CuZn Spa Filter, Jacuzzi Hot Tub
Filter and Hot Springs Hot Tub Filters
Spa Filter Cartridges that Reduce the Need for
Chlorine and
Other Corrosive Chemicals
for Your Spa, Jacuzzi Hot Tub
CuZn Spa MaxiDisk Filter Cartridges are Filter Foam Disks
that safeguard your spa and Jacuzzi hot tubs by reducing the need for
chlorine and other chemicals that corrode pipes and equipment. Plus,
chemical costs are minimal. After heavy loads from excess bathers, heavy
rain, wind or pets, a one-time shock treatment, with potassium monopersulfate
or other shocking agents, is sufficient to solve the problem. The spa
and Jacuzzi hot tub MaxiDisks and Spa Core filters also help to neutralize
slightly acidic water, thereby reducing or eliminating the use of pH
chemicals.
Water filtration inside the spa and Jacuzzi hot tub system takes place
as the water twists and turns through the MaxiDisks' or Spa Core's maze
of copper-zinc fibers. This tortuous movement increases contact time
with the disks during each pass through the media, as the water is recirculated
through the media over and over.
CuZn MaxiDisk for Hot Tub Skimmer Baskets $49.95
Reduce
Chlorine and Other Chemicals in Your Spa or Jacuzzi Hot Tub that Corrode
Pipes and Equipment and Damage Skin and Hair
CuZn's 4" MaxiDisk water filter for spas and hot tubs is easy-to-install
spa. No plumbing is required. The water filter disk size is 3 3/4" x
1".
To install, simply place the CuZn
Spa Power Disks on top of your water return and enjoy clean, chemical-free
water with no effort. The CuZn MaxiDisk is recommended for spas and
hot tubs up to 400 gallons and lasts 4 months.
NOTE: The CuZn
MaxiDisk for Hot Tub Skimmer Baskets is not refillable because it does
not come with casing. To replace the filter, buy a new MaxiDisk.
How CuZn MaxiDisk Works
Foam MaxiDisks use an all-natural
process that works by catalytic action and the redox (reduction/oxidation)
principal of dissimilar metals. As water passes through the Power Disks,
a chemical reaction causes zinc and copper hydroxides to form in controlled
amounts. These controlled releases of copper and zinc oxides are carried
into the filtered water where they provide hostile conditions for bacteria,
algae and fungus growth. This means cleaner water for bathing, plus
reduced time and labor in keeping the spa or hot tub clean.
The Filter Foam technology uses
disks to provide excellent, chlorine-free water for swimming pools
and spas through filtration rather than the introduction of chemicals
to the water. Chlorine attacks organic matter, and your skin is your
body's largest organ. Chlorine irritates eyes, nose membranes, and
lungs and it leaves skin and hair dry and flaky. Studies have shown
that long-term exposure to chlorine can be harmful to your health.
Hydrogen peroxide alternatives to chlorine can also cause allergic
reactions and can permeate the spa or hot tub walls.
Filter Foam Disks use a unique form
of KDF copper-zinc media which has been molded, via a proprietary process,
into a soft disk that looks like a gold sponge. KDF is excellent at
removing chlorine for long periods of time while also acting to reduce
hardness (scale) and maintaining a bacteriostatic environment that
inhibits bacteria growth. KDF meets NSF Standards 42 and 61 and has
been tested to remove heavy metals and inorganics as well as chlorine
from water. KDF releases low residual copper and zinc ions into the
water to inhibit algae and fungus growth.
Using the MaxiDisk
Water flowing through the MaxiDisk
is what makes it work. A pool or spa needs to circulate the water
to provide maximum contact with the disk. The best way to do this
is to circulate the water for at least 12 continuous hours each day
at 10 gpm (gallons per minute) in spas or the normal flow rate for
pools 24 hours 7 days a week. Do not allow suctioning except at the
skimmer or wherever the disk is placed. If 12 continuous hours is
not possible, use the pump to circulate the water for two, 2-hour
periods daily and run the pump at low speed for at least 30 minutes
after each spa use.
Don't worry about pH with the
disks. They regulate themselves usually between 7.6 and 8 and occasionally
from 7.4 to 8.2. Chemicals intended to control pH severely reduce
the disk's efficiency. Most pH parameters for pools and spas are
based on using chlorine and are not relevant when the disk is used.
Likewise, the disks tend to regulate
water's softness. The main reason water is hard is that calcium is
present. The MaxiDisk and MegaDisk do not remove calcium, but they
make the water act softer by changing calcium's cellular morphology
so that it cannot adhere to a surface. The calcium does not deposit
scale on surfaces.
If you test the water for softness
in a MaxiDisk or MegaDisk treated pool or spa, however, the test
will show any calcium present because it does not distinguish between
calcium's various morphologies.
There are no health issues with
the disk's capacity to make water act softer. Using chemicals to
soften the water, in addition to the disk, will restrict the efficiency
and life of the disk. In normal operating conditions using the disk,
no chemicals are needed for softening.
The MaxiDisk for spas does not
have a disk guard because spas usually have sediment filters to remove
debris, soap or oil. Check your MaxiDisk periodically to make sure
it is not clogged as this would reduce the flow of water through
the disk. If you notice debris or material on the disk, remove the
disk, clean it with water and replace it.
CuZn Water Filters are made in the U.S.A. and are Duty FREE to Canada
Healthy Lifestyle News
Acquire what you need to improve your health, fitness and youthfulness
regardless of your present health situation. Delivered monthly, each
issue includes an inspiring quote, and a variety of motivating, inspiring
or thought provoking articles, stories and tidbits about nutrition, diet,
body wisdom, weight management, fitness and staving off aging.